AH-6
*Wire length requirements: 1.8 MHz band: 30 m (65.6 ft) or more, 3.5 MHz band and above: 7 m (23 ft) or more. A ground connection is required. Tuning may not be possible, depending on the environment and conditions. SO-239 Antenna Connector for 50 Ω Antenna The SO-239 antenna connector provides a direct connection to a 50 Ω antenna. Both long wire and 50 Ω antennas, such as verticals and dipoles, can be used* and are selectable with a switch.
*Do not connect two antennas at the same time to prevent damage to the antenna tuner during transmission. Compact & Lightweight Body for Portable Operation The same compact size as the AH-4, 50%* smaller and lighter than the AH-730. Cables can be connected without opening the cover, enabling quick and easy installation. High Speed Tuning Simply press the "TUNER" switch on the connected transceiver for fully automatic tuning in 2–3 seconds. The 200-channel memory stores matching settings, enabling re-tuning at the same frequency in approximately one second. Minimised Interference During Tuning During tuning, the AH-6 reduces RF output to approximately 0.3 W through the attenuator, minimising interference with other stations. IP54 Rugged Construction for Outdoor Installation The body is made of a high-rigidity resin. With a water-resistant structure that includes waterproofing, weather resistance and protection against salt damage, it can be safely installed in various outdoor locations.
- IC-7100
In 1995, almost three decades ago, Icom changed the way radio hams thought about mobile HF communication with the introduction of the IC-706. Since that time, the Icom Mobile HF radios have been the Performance HF mobile radio of choice. Now, Icom has once again changed mobile HF communications with the introduction of the IC-7100. - IC-718
The IC-718 is a compact rig with ample features for HF communications. The HF bands enable you to communicate across long distances, even reaching the other side of the Earth. With its wide dynamic range, high S/N ratio, and full-duty operation, you will make contacts easily. Experience the combination of RF and digital technology, and you will realise that the IC-718 is probably the most practical rig you will ever need. - IC-7300
The IC-7300 is a revolutionary compact radio that will excite HF operators from beginners to experts. This model has a high-performance real-time spectrum scope and employs a RF direct sampling system. The IC-7300’s real-time spectrum scope provides top-level performance in resolution, sweep speed and dynamic range. While listening to received audio, the operator can check the real-time spectrum scope and quickly move to the intended signal. The combination of the real-time spectrum scope and waterfall function improves the quality and efficiency of HF operation. - IC-7300MK2
The IC-7300MK2 is the much-anticipated successor to the wildly successful and world-renowned IC-7300. Building on a legacy of excellence, the IC-7300MK2 sets a new standard for HF operation. With dramatically enhanced performance, including superior RMDR, lower phase noise and the addition of features such as an HDMI port and a built-in CW decoder, this transceiver is set to redefine your time on the air. - IC-7610
Whether it is poor band conditions, or battling to pick out a call in a large pile-up, faint signals have always been a challenge for DXers and Contesters around the world. The difference between putting the QSO in the log or having to try another time is the capability of your receiver. One key factor is the RMDR capabilities, the ability to pick out a faint signal in the presence of stronger, adjacent signals. The IC-7610 introduces dual RF direct sampling receivers, achieving 110dB RMDR, rivalling that of top-of-the-line transceivers. - IC-7760
In today’s connected world, the IC-7760 introduces a new connected system consisting of a remote control head and RF deck connected with a commercially available control (LAN) cable. This concept increases the flexibility of your station installation, making more space available on the desktop by placing the RF deck in an area closer to the antenna feed point. In addition to the direct connect feature, control head to RF deck, utilise your home network to make any tabletop your shack and a PC is not required! - OPC-1465
Shielded control cable